Concrete & Masonry · Concrete & Materials

How to Calculate Concrete for a Slab

Use consistent dimensions, convert thickness to feet, and calculate the net pour before adding a separately chosen allowance.

Concrete volume = length × width × thickness. Convert all three dimensions to feet for cubic feet, then divide by 27 for cubic yards. Calculate the net volume first; choose any extra ordering allowance separately.

A slab estimate is only as dependable as its dimensions. The Concrete Calculator accepts slab measurements and can show volume in cubic yards, but it cannot inspect the form, subgrade, or delivery conditions. Use the steps below to check the number before planning a pour.

The slab volume formula

For a level rectangular slab, multiply the inside length and width of the form by the planned concrete thickness. Keep the dimensions in one unit system before multiplying.

  • Cubic feet: length (ft) × width (ft) × thickness (ft)
  • Cubic yards: cubic feet ÷ 27
  • Metric: length (m) × width (m) × thickness (m) gives cubic meters

One cubic yard is 27 cubic feet. Do not enter thickness in inches alongside dimensions in feet without converting first: divide inches by 12 to get feet.

Measure the slab

Measure the pour area inside the form, not the outside of the boards. For a simple rectangle, record the two perpendicular inside dimensions. Measure the planned thickness from the prepared base to the top of the slab in several places if the base is uneven; a single nominal thickness can understate volume when the depth varies.

For an L-shaped or stepped footprint, split the plan into non-overlapping rectangles, calculate each section, and add the volumes. If the thickness changes, calculate each zone with its own thickness. Avoid counting shared areas twice.

Worked example

Suppose the inside form measures 12 ft by 10 ft and the planned slab thickness is 4 in. Convert thickness to feet: 4 ÷ 12 = 0.3333 ft.

12 × 10 × 0.3333 = 40 cubic feet. Then 40 ÷ 27 = 1.48 cubic yards (rounded for display). The unrounded result is about 1.4815 cubic yards; keep that precision until the final display.

Add an ordering allowance

Net geometric volume is not automatically the amount to order. Form movement, an irregular base, spillage, and measurement uncertainty may change the delivered quantity. If you use an allowance, show it as a separate assumption: adjusted estimate = net volume × (1 + allowance rate). For example, a user-selected 5% allowance on 1.4815 yd³ gives about 1.56 yd³. Five percent is an illustration, not a universal recommendation.

Bagged mix and ready-mix are ordered differently. For bags, use the yield printed on the exact product package and round up to a whole bag. For ready-mix, confirm supplier minimums, dispatch increments, access, and placement constraints directly with the supplier.

What this estimate leaves out

This calculation estimates geometric volume. It does not determine reinforcement, slab design, subgrade preparation, drainage, joints, code compliance, permits, or whether the planned thickness is suitable for a load. Check project requirements with the local building department and a qualified professional where needed.

FAQs

How many cubic yards are in a 10 × 10 slab?

The answer depends on thickness. At 4 inches thick, the net volume is 100 × (4 ÷ 12) = 33.33 cubic feet, or about 1.23 cubic yards.

Should I round up the cubic-yard result?

Keep full precision during the calculation, then discuss the final order quantity with the ready-mix supplier. Do not assume the calculator's rounded display is a supplier's order increment.

Does the formula work for a sloped or uneven slab?

It gives a planning estimate only when one representative thickness describes the whole area. A varying depth should be divided into zones or measured by someone familiar with the project.