4 guides · 2 calculators

Roofing Guides: Pitch, Roof Area, Squares, and Shingle Bundles

Roof quantities start with slope. A building footprint is a horizontal projection; the roof surface is larger, and the difference comes from pitch.

These guides cover the steps behind the Roofing Calculator: measure the roof planes or use a simple footprint and pitch, convert the result to squares, and turn that area into bundles. The estimate is a quantity plan, not a framing, ventilation, or installation design.

Start here

  1. Measure the pitch

    Find rise over a 12-inch run from an accessible rafter. Pitch is not the rafter length or an angle in degrees.

  2. Choose the area method

    Use a footprint with one pitch for a simple plan, or enter measured roof planes directly when the roof is not a simple rectangle.

  3. Convert to squares

    One roofing square is 100 square feet of roof surface, not 100 square feet of footprint.

  4. Use the product's bundle coverage

    Check the wrapper or data sheet. A common three-bundle square is not universal across products.

Calculators for this task

Start with the main calculator when you already have measurements. The related tools cover the conversion or order step that follows.

Measure pitch

Record rise and run before converting anything. The angle and the pitch number describe the same slope in different ways.

Roof area and squares

Measure the actual roof planes, or convert a simple footprint with one pitch. Both end at sloped area and roofing squares; do not count the same surface twice.

Shingle bundles

Bundle coverage is a product figure. The guide uses the package coverage rather than treating bundles per square as a fixed rule.

What changes the answer

  • Pitch is rise over run. An angle in degrees is a different reading of the same slope, not a replacement for the rise-over-12 notation.
  • The footprint method needs one pitch and a simple plan shape. Complex roofs need measured planes or separate sections.
  • A plane-by-plane takeoff is not the same as applying one pitch factor to the whole footprint. Hips, valleys, and dormers add planes and cuts.
  • Roofing squares are surface area. Bundle coverage is a product figure and can change with the shingle line.
  • An allowance is separate from the sloped area. The calculator does not add a universal waste percentage.
  • The estimate does not design framing, ventilation, underlayment, flashing, or code compliance.

Questions about these guides

Can I use the footprint if I haven't measured the roof?

Only with a single pitch and a simple shape. Otherwise measure the roof planes or split the roof into sections so one pitch is not applied to the whole house.

Should I measure the roof planes or use the footprint?

Use measured planes for a complex roof, multiple pitches, or dormers. A single-pitch footprint conversion is a shortcut for a simple plan, not a substitute for a takeoff.

How many bundles are in a square?

It depends on the product. Check the package coverage instead of assuming three bundles per square for every shingle.

Does the calculator subtract skylights or chimneys?

No. Roof area comes from the roof planes or the footprint and pitch. Openings and obstructions need their own adjustment.

Can I measure pitch from inside?

The guide shows the attic method when a rafter is safely accessible. Do not treat it as roof-access advice or as a substitute for a site inspection.